Key Features Accurate “bulls eye” pinpointing on coin size targets up to 3″ + deep depending on settings, ground and moisture conditions! NEW light weight, compact, waterproof/submersible 1″ X 6″ probe (not pictured) and new single Clip Attachment Kit (also not pictured). Comes with a very flexible heavy duty custom 32″ straight cable with strain relief for “tangle free” operation, and mounts nicely along the Explorer’s battery compartment or on top of upper shaft. New red Probe Tip Cover (not pictured) installed to prevent wear and tear on the probe tip. Replacement covers available from your authorized, stocking Sun Ray Dealer. Very compact, ultra light switch box mounted on bottom of upper shaft makes for easy switching from coil to probe. Makes coil changes super fast as coil cable will no longer be inserted into upper shaft! While the X-1 probe is waterproof the switch box is water resistant and must not be submersed. X-1 gives operator ALL of the same functions as stock coil including accurate visual and audible target ID in both Smartfind & Digital mode, non-motion pinpoint, etc. (Depth reading will be off due to the probe’s diameter which is normal.) Quality high performance toggle switch used for peak performance! (Minimum 100,000 mechanical life operation-as described in manufacturer’s specs) Toggle switch shuts off coil as it turns probe on and vise versa. Coil and probe are never on at the same time. No external buzzers or lights are needed as all targets are heard clearly through your detector headphones! No extra batteries required as the X-1 utilizes the detectors power source. Complete installation & operation instructions included. Comes attached to Minelab middle shaft.